Did not know that! Thanks for the info
Might be old news to some.
But, some new hands may not know.
But, if you ever decide you want a DIY sump.
And, need to put a bulkhead in it.
Electrical conduit fittings work perfectly.
They can be found at Lowes, HomeDepot, etc.
They come in 1/2, 3/4 & 1 inch.
They are about 0.50 cents each.
1 male, 1 female & a gasket.
Simple as that.
Maybe this belongs in the DIY section?
I miss John Belushi (January 24, 1949 – March 5, 1982)
I miss Gilda Radner (June 28, 1946 – May 20, 1989)
They just don't make them, like they use to.
Did not know that! Thanks for the info
I think I would be very hesitant to use this fitting considering the risk and cost of a regular bulkhead fitting.
Electrical bulkhead fitting are designed to be weather-tight and not submerged. Submerged fittings have a much larger gasket or seal area.
Use with caution!
Bob B.
I've done the exact same thing with regular PVC fittings and bathdrain gaskets. No problems on my end.
________________
Jose
The thing that needs to be watched out for with regular PUC fitting is that they are tapered. They are not made to screw together tight as electrical PVC is.
Although I've used other fittings ........A proper Bulkhead is still the way to go
I agree, a normal bulkhead is better.
As the flange area is wider.
I would not use one of these on an aquarium.
But, have used them on sumps & the like.
With no bad experiances, over years.
In my case it is a 60 mile round trip drive to get a normal one.
(30 there & 30 back)
Or, wait for mail/order to arrive in the mail.
With these, Lowes/Home-Depot is only a few minutes away.
Which just makes it quick & handy, in a pinch.
I miss John Belushi (January 24, 1949 – March 5, 1982)
I miss Gilda Radner (June 28, 1946 – May 20, 1989)
They just don't make them, like they use to.
I have seen these used by people that I know and they never had an issue with them either.
Scott